2022+ Nissan Frontier Titan Swap Kit with Dobinsons MMR Coilover Struts. This kit offers an increase in suspension travel with Z1 Titan FUCAs, Titan suspension components, appropriate spacers, and Dobinsons Coilover struts. These approved packages have been tested in droop and bump travel to ensure we don't bottom out a strut or over travel a CV axle or tie rod end (leading to premature failures).  Titan swaps paired with the appropriate spring typically lift the front of a truck 3.5-4 inches while increasing the wheel track/stance by ~6 inches. Not only is the track widened but all of the factory suspension stress points are relieved, allowing you to conquer each trail with confidence.

This kit only services the front of the vehicle. Z1 recommends adding additional lift components to the rear of the vehicle.

Disclaimer: Front Struts do not come fully assembled (strut mount kits included).

Includes:

• Z1 Titan Front Upper Control Arms (FUCA)
• Titan Front Lower Control Arms (FLCA)
• Inner Tie Rods
• Outer Tie Rods
• Z1 Front Strut Lift Spacers
• Z1 Front Strut Mount Kits
• Dobinsons Twin Tube Shocks
• Dobinsons Springs*

* This kit comes with teal springs, if you want a different color (red or black) please contact our sales team prior to purchasing.

Specifications:

• Dobinsons Twin Tube
• Part Number - GS45-642
• Measured Travel - 8.3 Inches

Z1 Front Upper Control Arms

Z1 Control Arms are fully forged and machined from a single chunk of 6061 aluminum. Stainless steel double adjusters are utilized on the inner joints, allowing adjustments to alignment without having to remove the arms from your truck. Each arm features teflon-lined spherical heim joints for quiet operation and quicker response. Extreme-duty grease-able ball joints provide a quiet and comfortable ride without compromising offroad performance.  Each joint features 66° of articulation which is more than enough for most extended suspensions using OEM axles. Billet dust caps are attached above the ball joint, keeping dust, dirt, and water away from the service fitting.

These arms are designed for maximum coil bucket clearance, preventing contact on lifted trucks or trucks with extended-travel suspension. Their high-clearance design provides excellent articulation when used with extended travel suspension. Installation requires no modifications to frame mounting points and double adjusters make alignments a breeze!

It is highly recommended to also purchase the following with this kit:

• Frontier Extended SS Lines
• Extended CV Axles
• Front Upper Control Arm Hardware
• Eccentric Bolt Kit or Z1 Off-Road Offset Eccentric Lock-out Kit

Fits:

• 2022+ Nissan Frontier (D41)
  

 Note: Please be sure to select the correct Spring Rate / Color option from the drop-down provided prior to adding to cart. Review the Spring Options and Specifications prior to adding to cart.