The Titan Swap Parts Plus kit is made up of our standard Titan Swap Parts Kit with Z1 Forged Upper control arms, plus it includes the appropriate spacer for a range of popular struts. These approved packages have been tested in droop and bump travel to ensure we don't bottom out a strut or over travel a CV axle or tie rod end (leading to premature failures). Titan swaps paired with the appropriate spring typically lift the front of a truck 3.5-4 inches while increasing the wheel track by ~6 inches. Wheel travel with most of these kits is increased from the factory 5.8" to 8-8.5" depending on your strut of choice.
This kit only services the front of the vehicle. Z1 recommends adding additional lift components to the rear of the vehicle.
Disclaimer: Front Struts/Springs are not included with this kit. Select which front struts you have installed to receive the appropriate lift spacer with your kit.
Includes:
| Strut Series |
Strut Part # |
Measured Travel
(inches) |
NOTES |
| 4600 |
24-137430 |
8 |
Extended Bumpstop Recommended |
| 5100 |
24-187053 |
8.5 |
|
| OME |
ARB90003 |
8.3 |
|
| Dobinsons Twin Tube |
GS45-642 |
8.3 |
|
| Dobinsons MRR Std |
MRA45-A642 |
6.25 |
|
| Dobinsons MRR Ext |
MRA45-A648 |
|
Can mod bump .4" shorter dependent on CV |
| Dobinsons IMS Ext |
IMS45-50648 |
8.13 |
Can mod bump .4" shorter dependent on CV |
Z1 Front Upper Control Arms
Z1 Control Arms are fully forged and machined from a single chunk of 6061 aluminum. Stainless steel double adjusters are utilized on the inner joints, allowing for easy adjustments to alignment without having to remove the arms from your truck. Each arm features teflon-lined spherical heim joints for quiet operation and quicker steering response. Extreme-duty grease-able ball joints provide a quiet and comfortable ride without compromising offroad performance. Each joint features 66° of articulation which is more than enough for most extended suspensions using OEM axles. Billet dust caps are attached above the ball joint, keeping dust, dirt, and water away from the grease fitting.
These arms are designed for maximum coil bucket clearance, preventing contact on lifted trucks or trucks with extended-travel suspension. Their high-clearance design provides excellent articulation when used with extended travel suspension. Installation requires no modifications to frame mounting points and double adjusters make alignments a breeze!
It is highly recommended to also purchase the following with this kit:
Fits:
- 2005-2015 Nissan Xterra (N50)
- 2005-2019 Nissan Frontier (D40)
 |