Z1 Frontier 4.0L Silicone Master Hose Set

Only thing is if you have any aftermarket k&n type intake that tubing isn't long enough.

Good quality and there is a parts placement chart to help with installation

A nice upgrade from factory style hoses. Moulded hoses fit into position well and have held up to the abuse.

Makes the engine department look better and gives you that long-term insurance policy that when you’re done at Moab or up in Alaska during the dead of winter, you won’t have a whole split on you.

Great set that allows me to address the concern on when a stock hose will fail. Perfect fit, looks great, and will last a long time. Bought the master set to save with the bulk buy approach, as all stock hoses will eventually leak and require replacement.

Worth every penny and fairly straight forward to install. I wish it came with a sheet describing which system each group of hoses were associated. You can find it on the website but it is a little annoying having your phone out there on the engine and IDing hoses. This is a little gripe. A tip. There are a couple of hoses (power steering and cooling) that it is so much easier to install if you remove the passenger side inner fender liner. There are 2 hoses that I did not install due to effort / difficulty. There is an angled hose that connects a coolant pipe to the intake valley on the motor. At first glance I could not see how to replace that without completely removing the entire intake. Not just the upper intake the whole thing. There is a short hose that attaches to the overflow container. You will need to pull the overflow and unbolt the fuse block area to replace it. All the other hoses are pretty straight forward to install and worth the time. They should offer a total kit with their bleeder replacement, this hose set and Dorman 626-598. IMO it makes the water system as close to bulletproof as possible for the Frontier 4.0. .

Top quality product and looks amazing